PC104p4IP
PC104p4IP is a PC/104+ carrier design with 4 IP slots
|
PC104pIP
PC104pIP is a PC/104+ carrier design with 1 IP slot
|
Driver: Carrier driver for Win®XP & 2000
|
PCI2PC104p
Use your PC/104p boards in a standard PC. Two orientations supported for production mode and test.
|
PC104p-BiSerial-III
PC/104+ module with DMA, FIFOs, RS485/LVDS (16)transceivers, programmable direction and termination, 4-DAC, 4-ADC, TTL port
|
DINRibn64
The DINribn64 cable set is designed to interconnect devices using 64 connection DIN connectors. Rows A and C are utilized. Many Dynamic Engineering products have this connector system as well as products from third parties for VME systems. Utilize the DINribn64 cable to connect the DINterm64 to the PCIBPMC, PCIBPMCX2, PCI2PMC etc. A snap together breakout system with DIN rail capability is created with these components. You can also use the DINribn64 to interconnect your rear IO VME hardware to the DINterm64 or other breakout device.
|
DinTerm64
DINterm64 provides a space efficient, low cost method of interconnecting the control electronics to the rest of the sensors, IO, machinery etc.
|
PC104p2PMC
The PC104p2PMC ( PCI-104 to PMC ) adapter / carrier converter card provides the ability to install a PMC card into a standard PCI-104 slot
|
PC104pPWR12
The PC104pPWR12 power supply provides for the +5, +3.3, +12, minus 12 and minus 5 from a 12V wall mount transformer supply, battery etc. Each rail is fuse protected. The supply uses switching technology to provide high efficiency coupled with low pass filtering to provide low noise and fast response to transient loads.
|
