PC104p-COOL
Fan board with 2 positions

"Zero Slot Fans"™ available
Shown with fan and connector options - mix and match connectors, fan orientations, and power source as needed






Three versions are available to meet your requirements; PC104-COOL, PC104p-COOL. PCI-104-COOL. The difference between the versions is which connectors are installed. Multiple "COOL cards" can be installed per stack. All bus and power signals are passed through.

The fans can be mounted to blow in the standard direction or reversed. The Reverse direction is from the primary component side toward the secondary component side to provide cooling to the the board under the fan card and throughout the stack. The Forward direction will blow to the front and cool the rear side of the card above the "COOL" card in the stack.

The "Zero Slot Fans"™ are designed for low intrustion on either side of the PCB: .105" on the rear for the "F" model and .08" for the "R" model. The low profile fans used have 4.7 CFM using 12V. The fans draw 50 mA each for a maximum of 100 mA on the 12V rail with a completely filled board.

Standard profile fans can be used in place of the low profile ones to provide more air flow per fan. Approximately 8 CFM per fan. The current is higher as well. The standard profile fans may require a spacers within the stack.




  • 1 year warranty
  • Quantity discounts available

  • Ordering Information
  • PC104p-COOL-X Both connector positions and both fan positions filled
  • PCI-104-COOL-X PCI connector position only and both fan positions filled
  • PC104-COOL-X ISA connector position only and both fan positions filled
    X = R for Reverse => blow to the rear onto the component side of the card below
    X = F for Forward => blow to the front onto the solder side of the card above

    Fans can be installed - mixed - one R and one F to create turbulence and airflow within the stack. Add both direction indicators for this option.

    For higher velocity fans add "-HV" to the end of the part number. 12 V fans will be used.


    Please select your fan options and orientation below
    Install locations - fill in the locations and direction of the air flow. The default selection is both positions Forward. Selecting "NI" will remove that fan.
    Fan direction:
    F= Fan blows back to front
    R= Fan blows front to back
    Selecting HV fans will require a spacer not included

    Please select your fan options and orientation below
    Install locations - fill in the locations, and direction of the air flow. The default selection is "NI" Not-installed locations.
    Fan direction:
    F= Fan blows back to front
    R= Fan blows front to back
    Selecting HV fans will require a spacer not included
    Please select module type - PCI-104 [PCI connector only] PC104p[Both Connectors], PC104[ISA side only]

    Quantity


    This product is simple enough that a manual is not required. If you do have questions please direct them to sales@dyneng.com or support@dyneng.com.


    Custom, IP, PMC, XMC, PCIe, PCI, cPCI, VME, VPX Hardware, Software designed to your requirements



    Home | News | Search the Dynamic Engineering Site